Invacare RPL600-2 Owners Manual - Page 19
Mounting the Battery Charger
View all Invacare RPL600-2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
5.6 Mounting the Battery Charger Refer to your local regulations concerning proper mounting procedures. 1. Place the battery charger with mounting bracket on the wall at the desired position. 2. With a pencil, mark the middle hole position. 3. Measure down 6½ inches from the pencil mark and drill one mounting hole. 4. Install the bottom mounting screw until there is an approximate 1/8-inch gap between the screw head and the wall. 5. Install the battery charger with mounting bracket onto the bottom mounting screw. 6. Drill the remaining two mounting holes. 7. Install the two remaining mounting screws through the mounting bracket and into the wall. Tighten securely. 8. Plug the battery charger into the wall electrical outlet. 9. Verify that ON is illuminated. Mounting Bracket Battery Charger with Mounting Bracket (STEP 5) Mounting Screws 5 ASSEMBLY BOTTOM Mounting Screw (STEP 4) Part No. 1145810 19 Electric Portable Patient Lift