JVC FS-H100 Instruction Manual - Page 8
Getting Started
View all JVC FS-H100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Getting Started Unpacking After unpacking, check to be sure that you have all the following items. The number in parentheses indicates the quantity of each piece supplied. • AM loop antenna (1) • Remote control (1) • Batteries (2) If any item is missing, consult your dealer immediately. Connections To connect speakers You can connect the speakers using the speaker cords. 1 2,3 Putting the Batteries into the Remote Control Insert the batteries-R6(SUM-3)/AA(15F)-into the remote control by matching the polarity (+ and -) on the batteries with the + and - marking on the battery compartment. When the remote control can no longer operate the unit, replace both batteries at the same time. 1 LEFT RIGHT Gray Speaker cord Gray Gray with black stripe Speaker cord Gray with black stripe 2 R6(SUM-3)/AA(15F) Right speaker Left speaker 3 • DO NOT use an old battery together with a new one. • DO NOT use different types of batteries together. • DO NOT expose batteries to heat or flame. • DO NOT leave the batteries in the battery compartment when you are not going to use the remote control for an extended period of time. Otherwise, the remote control will be damaged from battery leakage. 1 Hold the clamp of the speaker terminal. 2 Insert the end of the speaker cord into the terminal. Match the polarity of the speaker terminals: gray cord (ª) to red (ª) and gray cord with black stripe (·) to black (·). 3 Release your finger from the clamp. IMPORTANT: • Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit. • DO NOT connect more than one speaker to one speaker terminal. 6