JVC FS-M3 Instruction Manual - Page 12
Listening to FM and AM Broadcasts
View all JVC FS-M3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Listening to FM and AM Broadcasts Tuning In a Station 1 When the unit is turned on, press TUNER/BAND to select tuner mode. The unit tunes in the last station tuned in (either FM or AM). 2 Press TUNER/BAND to select the band, FM or AM. Each time you press the button, the band selection alternates between FM and AM. 3 Press and hold 4 or ¢ for more than 1 second. The unit starts searching for stations and stops when a station of sufficient signal strength is tuned in. If a program is broadcast in stereo, the STEREO indicator lights up. To stop searching, press 4 or ¢. BAND TUNER BAND TUNER SEARCH/TUNING When you press 4 or ¢ briefly and repeatedly The frequency changes step by step. Presetting Stations You can preset 20 FM and 20 AM stations. • There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again. 1 Tune in the station you want to preset. • See "Tuning In a Station" on the left. 2 Press PROGRAM. The PROGRAM indicator and "00" start blinking on the display. PROGRAM 3 Press PRESET ∞ or 5 (or REPEAT/PRE DOWN or PRE UP on the remote control) to specify the desired preset number. PRESET REPEAT 4 Wait a few seconds to confirm the preset number. • Alternatively, press PROGRAM. 5 To preset more stations, repeat the steps above, allocating a different preset number to each station. When a new station is stored The station previously memorized with the same preset number is erased. (The frequency of the new station replaces the previous frequency in memory.) Tuning In a Preset Station BAND 1 Press TUNER/BAND to TUNER select tuner mode. 2 Press TUNER/BAND to select the band, FM or AM. 3 Press PRESET ∞ or 5 (or REPEAT/PRE DOWN or PRE UP on the remote control) to select the desired preset number. PRESET REPEAT - 10 -