JVC GY-HM150U GY-HM150U ProHD Camcorder 104-page owner's manual - Page 32

Shooting Viewing Recorded Videos Immediately (Clip Review) You can check the most recently recorded video. However, the video clip cannot be played back if the settings of the camera recorder are different from the video format (Camera Resolution/Frame & Bit Rate) of the clip. (A Page 63) Memo : ● Clip Review is unavailable when Clip Continuous Rec is paused (ASTBYCB, yellow text) and when Frame Rec is paused (ASTBYFB, yellow text). To operate, press and hold the [REC] button or use the user button assigned with ARec StopB to set to ASTBYCB (white text)/ ASTBYFB (white text) first. (A Page 45) Zoom Operation ADJ./ VOL. PUSH W E E OGRAM A OGRAM A [REC/6] REC / 6 [REC] MENU/ THUMB T PR W REC SLOT SEL LOLUX/3 DISPLAY C.REVIEW/4 ZEBRA/5 OIIS SHUTTER AE ʶ REC DC [C.REVIEW/4] [REC] 1 Assign AClip ReviewB to any of the user buttons. By default, it is assigned to the [C.REVIEW/4] button. Memo : ● To use this function, assign AClip ReviewB to any of the user buttons. * [Main Menu]B[Camera Function]B[Switch Set]B[USER1]/ [USER2]/[LOLUX/3]/[C.REVIEW/4]/[ZEBRA/5]/[REC/ 6]BAClip ReviewB(A Page 67) 2 Press the button assigned with the AClip ReviewB function during standby (ASTBYB is displayed). ● Playback starts. The playback position changes according to the setting. [Last 5 sec/Top 5 sec/CLIP] (A Page 67) ● After playback ends, the camera recorder returns to the ASTBYB (recording standby) mode. C.REVIEW/4 Note : ● To start recording immediately during Clip Review, press [REC]. Doing so cancels Clip Review and enters recording mode. It will take some time to start recording after the button is pressed. ● To cancel Clip Review operation, press the user button assigned with the AClip ReviewB function again. ● During Clip Review, only the [REC] button and user button assigned with the AClip ReviewB function are enabled. ● When the last clip is less than 5 seconds, the whole clip is played back. ● Only video clips in the currently selected slot can be reviewed. ● When there are no clips in the selected slot, Clip Review function is disabled. Applicable to: Full Auto shooting mode A, Manual shooting mode M Adjusts the angle of view. Zoom ratio: 1x to 10x (optical zoom only) Zooming can be operated using any of the four levers/rings below. A Camera recorder's zoom lever on the top surface B Camera recorder's manual ring: This can be used as a zoom ring when the [FOCUS/ ZOOM] ring switch at the side of the camera recorder is set to AZOOMB. C Set lever on the LCD monitor D [ZOOM] button on the remote control The priority order of these levers/rings is in the sequence A > B > C > D. B Manual Ring A Zoom Lever W T ND FILTER ON OFF USER1 USER2 FOCUS ZOOM AF/MF FULL AUTO GAIN WHT.BAL IRIS A/M L- B- M- A- H- PRST- A Ring switch set to AZOOMB MENU/ THUMB T PR W B REC C Set Lever on LCD Monitor Ⅵ A zoom bar appears during zoom operation. W T 28