JVC GY-HM650U Operation manual for the GY-HM650U (168 pages) - Page 66
Setting Time Code without Opening the, Recording Time Code in Continuation
View all JVC GY-HM650U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
Shooting Setting Time Code without Opening the Menu MENU/THUMB CANCEL MENU/THUMB AE LEVEL CANCEL FOCUS ASSIST/1 OIS / 2 TIME CODE . Memo : Settings cannot be made in the following cases. [TC/UB]-[TC Generator] has been set to "Regen". Menu screen is displayed. The camera recorder is not in the Camera mode. Setting Time Code Set [TC/UB]-[TC Generator] to settings other than "Regen". (' P102 [ TC Generator ] ) Hold down the [MENU] button and press the [FOCUS ASSIST/1] button. The [TC Preset] setting screen appears. Cursor Check the values and press the Set button (R). The time code is set and the screen returns to the normal screen. To cancel the setting, press the [CANCEL] button. Caution : When the camera recorder is switched to Media mode during editing, editing will be canceled and the screen will close. When editing the time code, operation of the [FOCUS ASSIST/1] and [OIS/2] buttons that are configured in [Main Menu]-[Camera Function]-[User Switch Set] is disabled. The [OIS/2] button functions as the number reset button. (' P97 [User Switch Set Item] ) Recording Time Code in Continuation of the Recorded Time Code on SD Card This camera recorder is equipped with the time code reader. Set [TC/UB]-[TC Generator] to "Regen". When the camera recorder enters from recording standby mode to recording mode, it reads the time code already recorded on the SD card and records the new time code in continuation of that value. The same data as the user's bit already recorded on the SD card is recorded. Memo : When [TC/UB]-[TC Generator] is set to "Regen", the framing mode of the time code follows the settings in [TC/UB]-[Drop Frame] instead of the clip settings. (' P102 [ Drop Frame ] ) During drop frame During non-drop frame . Set the time code (hour, minute, second, frame). Use the crossshaped button (HI) to place the cursor at the item to set, then use the cross shaped button (JK) to change the values. Memo : Press the [OIS/2] button to reset each digit to "0". The cursor moves to the time digit (left). 66