JVC HR-XVS44U Instruction Manual - Page 71

EDITING (DVD DECK) Digital Audio Dubbing ● Turn on the TV and select the VCR channel (or AV mode). ● Slide the TV/VCR/DVD switch to the right. Recorder Digital audio device (MD deck etc.) Optical cable (not supplied) Player Rear of unit DIGITAL AUDIO OUT Note for connection: Remove the connector cover from the unit and remove the protection cap from the cable. EN 71 You can dub selected audio from the DVD or Audio CD disc to a MD etc. However, it is not possible to dub the copy-protected disc. Example: Dubbing to a MD A Make connections. Connect the optical cable between the unit and the digital audio device. B Place a disc and load a MD. For the DVD deck A Press OPEN/CLOSE (x) on the DVD deck to open the disc tray. B Place the disc in the disc tray. C Press OPEN/CLOSE (x) on the DVD deck to close the disc tray. For the digital audio device Insert a MD. C Prepare the DVD deck for dubbing. A Press DVD and select the audio to be dubbed. B Search for the point where you want to start dubbing by pressing PLAY (4), FF (5) or REW (3) then press STOP (8). C Press REW (3) a little, then press PLAY (4) to start playback. D Press PAUSE (9) to pause playback a little before the start point. D Prepare the audio device for dubbing. Select the input mode. E Start dubbing. A Press PLAY (4) to start playback on the DVD deck. B Start recording on the audio device. F End dubbing. Stop recording on the audio device. Then press STOP (8) to stop playback on the DVD deck. NOTES: ● There may be a discrepancy of several seconds between where you intend editing to start, and where it actually starts. ● You can also dub a Video CD or SVCD. Set "DIGITAL AUDIO OUTPUT" to "PCM ONLY". (੬ pg. 79)