Jabra CLIPPER User manual - Page 5
Getting Started, Charging Your Jabra Clipper, Turning Your Jabra Clipper On And Off, Pairing Your - manual
UPC - 615822001700
View all Jabra CLIPPER manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
english GETTING STARTED Follow these three steps before using your headset: 1 Charge your headset (approximately 2 hours) 2 Activate Bluetooth® on your mobile phone (refer to the manual for your mobile phone) 3 Pair your headset to your mobile phone CHARGING YOUR JABRA CLIPPER Make sure that your Jabra CLIPPER is fully charged before you start using it for the first time. While charging, the battery indicator changes from red to green, when fully charged. Charging time is approximately 2h. You can use the Jabra CLIPPER during charging. Please note: The lifetime of the battery will be significantly reduced if your device is left uncharged for a long period. Jabra therefore recommends that you recharge your device at least once a month. TURNING YOUR JABRA CLIPPER ON AND OFF - Press and hold the Multi-Function button until the LED turns green to turn it on. - Press and hold the Multi-Function button until the LED turns red to turn it off. - The headset will automatically turn off after 10 minutes if not connected to a device. PAIRING YOUR JABRA CLIPPER TO A PHONE OR OTHER DEVICE Headsets are connected to phones or other Bluetooth® devices using a procedure called 'pairing'. By following a few simple steps, pairing can be done in a matter of seconds. 1. Put the headset in pairing mode 1.a. First time pairing - Turn on the headset and the Jabra CLIPPER will automatically enter pairing mode (indicator light is solid blue) and start searching for a device. Jabra CLIPPER 4