Kenmore 1694 Use and Care Guide - Page 5
instructions, foryourmodel,Usethefreezer, onlyasinstructed, inthis, Owner'sGuide, - chest freezer
View all Kenmore 1694 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
ThisOwner'sGuideprovidespecificoperatinginstructions foryourmodel,Usethefreezeor nlyas instructedinthis Owner'sGuideB, eforestartingthe freezerf,ollow these importantfirst steps. INSTALLATmON Choose a place that is near a grounded electrical outlet, Do Not use an extension cord or an adapter plug, For the most efficient operation, the freezer should be located where surrounding temperatures will not exceed 110°F (43°C), Temperatures of 32°F (0°C) and below will NOT affect freezer operation, Additional compressor heaters are not recommended, o Allow space around the unit for good air circulation. Leave a 3 inch (75 mm) space on all sides of the freezer for adequate circulation, Crating Screw -t "". Discard The'(4) Crating Screws And (2) Wood Bases Unpacking and Leveling :- Upright Models To LeveJ Chest Models: if needed, add metal or wood shims between foot pads and floor, Installation Installation NOTE: The exterior walls of the freezer may become quite warm as the compressor works to transfer heat from the inside, Temperatures as much as 80 ° F warmer than room temperature can be expected, For this reason it is particularly important in hotter climates to allow enough space for air circulation around your freezer, LEVELING The freezer must have all bottom corners resting firmly on a solid floor, The floor must be strong enough to support a fully loaded freezer, NOTE: it is Very Important for your freezer to be level in order to function properly, if the freezer is not leveled during installation, the door may be misaligned and not close or seal properly, causing cooling, frost, or moisture problems, To LeveJ Upright ModeJs: After discarding crating screws and wood base, use a carpenter's level to level the freezer from front-to°back, Adjust the plastic leveling feet in front, Y2bubble higher, so that the door closes easily when left halfway open, CLEANING Wash any removable parts, the freezer interior, and exterior with mild detergent and warm water, Wipe dry, Do not use harsh cJeaners on these surfaces. Do not use razor blades or other sharp instruments, which can scratch the appliance surface when removing adhesive labels, Any glue left from the tape can be removed with a mixture of warm water and mild detergent, or touch the residue with the sticky side of tape already removed, Do not remove the seria! plate. _To allow door to cbse and seaBproperly, DO NOT _et food packages extend past the front of shelves. Shelf Front