Kenmore 4689 Use and Care Guide - Page 26
cont'd
View all Kenmore 4689 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
General Care & Cleaning (cont'd) Warm & Ready TM Drawer Left Glide Pull up latch with finger Re_d 1. _ Replacing the Warm & Ready TM Drawer Turn power off before removing the drawer. 2. Open the drawer to the fully opened position. 3. Locate the latches on both sides of the drawer. 4. Pull up on the left glide latch and push down on the right glide latch. 5. Pull the drawer away from the range. 6. To clean the Warm & Ready TM drawer, gently scour with a soapy scouring pad; this will remove most spots. Rinse with a 1:1 solution of clear water and ammonia. If necessary, cover difficult spots with an ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean water and a damp cloth. Remove all cleaners orthe porcelain may become damaged during future heating. DO NOT use spray oven cleaners on the cooktop. To Replace the Warm & Ready TM Drawer: 1. Align the glide latches on both sides of the drawer with the slots on the drawer. 2. Push the drawer back into the range. Push down latch with finger Right Glide Electrical Shock Hazard can occur and result in serious injury or death. Disconnect appliance from electric power before cleaning and servicing the warmer drawer. Changing Oven Light Be sure the oven is unplugged and all parts are COOL before replacing the oven light bulb. Do not turn the oven light on during a self-cleaning cycle. High temperature will reduce lamp life. On some models an interior oven light will turn on automatically when the oven is opened. The oven light may be turned on when the door is closed by using the oven light switch located on the Electronic Oven control. The oven light bulb is covered with a glass shield held in place by a wire holder. THIS GLASS SHIELD MUST ALWAYS BE IN PLACE WHEN THE OVEN IS IN USE. e Light Bulb: BE SURE OVEN IS COOL 1. Turn the power off at the main source. 2. Wear a leather-faced glove for protection against possible broken glass. _J 3. Replace bulb with a 40 Watt appliance bulb only. 4. Press wire holder to one side to release glass shield, change bulb and be sure to replace glass shield. 26