Kenmore 7756 Use and Care Guide - Page 13

Warmer Drawer Removal • Preparing Bread Dough for theWarmer Drawer • Removing & Replacing Warmer Drawer Preparing Bread Dough for the Warmer Drawer The Warmer Drawer has a "Proof Bread" feature that can be used to help prepare bread dough. The recommended length of time to keep the bread dough in the Warmer Drawer is about 45-60 minutes. Be sure however to follow the recipe's recommended times. The prepared bread dough should be placed in a large bowl because the dough will nearly double in volume, Arrange the Warmer Drawer Rack in the downward position (See Fig. 1). Place the bowl on the rack in the Warmer Drawer and follow the Warmer Drawer and Bread Proof Control setting instructions at the top of this page. Warm & Ready TM Drawer Removal • Removing & replacing thewarmer drawer Fig.1 Rack in downward position Left=handrail and release Warmer drawer = &handle Removing and replacing the warmer (Warm & Ready TM) drawer ii.i........... Electrical Shock Hazard can occur and result in serious injury or death. Disconnect appliance from electric power before cleaning and servicing the warmer drawer. To remove the warmer drawer: 1. Turn powerOFF before removingthewarmerdrawer. 2. Open the warmer drawer completely. 3. On left warmer drawer rail, locate black release lever and press up with finger while pulling out slightly on the drawer handle. On right warmer drawer rail, locate black release lever and press down with finger while pulling out slightly on the drawer handle (See Fig. 1). 4. The warmer drawer should now be released from the rails. Remove warmer drawer (using level & square motion) completely away from the appliance. Right=hand rail and release Fig. 1 To replace the warmer drawer: 1. Pull the bearing glides to the front of the outer compartment glide channels until they snap into place (refer to Fig. 3). 2. Carefully line up both sides of the warmer drawer glide rails to the outer compartment glide channels located inside the empty warmer drawer compartment (Refer to Fig. 2). 3. While holding the warmer drawer level and square using the warmer drawer handle, push (DO NOT FORCE) the warmer drawer all the way into the outer compartment glide channels all the way into the range. Pull the drawer open again to verify the glides have seated. 4. If you do not hear the levers "click" or the bearing glides do not feel seated remove the warmer drawer and repeat steps "1" through "3". This will minimize possible damage to the bearing glides. [qOTEI The wa[mer drawer will NOT operate while in the Self:Clean and Glide oven Lockout modes 13