Kenwood 108S Instruction Manual - Page 13
Connecting Wires to Terminals
UPC - 019048112064
View all Kenwood 108S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Connecting Wires to Terminals Fuse (10A) FM/AM antenna input If no connections are made, do not let the wire come out from the tab. Wiring harness (Accessory1) Connect either to the power control terminal when using the optional power amplifier, or to the antenna control terminal in the vehicle. P.CONT.OUT Power control/Motor antenna ANT. control wire (Blue/White) CONT. White/Black FRONT • L White Gray/Black FRONT • R Gray To front left speaker To front right speaker Ignition key switch ACC Ignition wire (Red) Green/Black REAR • L Green Purple/Black REAR • R Purple To rear left speaker To rear right speaker Car fuse box (Main fuse) Car fuse box Battery wire (Yellow) Ground wire (Black) · (To car chassis) + - 2CAUTION Battery 2WARNING If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box. When only two speakers are being connected to the system, connect the connectors either to both the front output terminals or to both the rear output terminals (do not mix front and rear). For example, if you connect the + connector of the left speaker to a front output terminal, do not connect the - connector to a rear output terminal. - 13 -