Kenwood CMOS-130 Operation Manual 1 - Page 5

After adjusting the camera angle, tighten the, retaining screws firmly., Fix the camera firmly

Get Kenwood CMOS-130 PDF manuals and user guides View all Kenwood CMOS-130 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 5 highlights

10 After adjusting the camera angle, tighten the retaining screws firmly. Inspect the retaining screws at times. If they are loose, tighten them firmly. 11 Fix the camera firmly in position. Peel off the paper liner from the double-side adhesive tape on the camera bracket and attach it. After attaching, push the camera bracket with your finger to ensure close adhesion. Do not touch the adhesive surface with your hand or peel and reattach an attached tape, as these will degrade the adhesive force and may cause the camera bracket to be detached. If required, secure the bracket on the vehicle body using the camera bracket clamping screw. The camera bracket has two holes for the screw. Select one of them to fit the position of the attachment. Camera bracket clamping screw (M3 x 8mm) ENGLISH | 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
ENGLISH
|
5
10
After adjusting the camera angle, tighten the
retaining screws firmly.
Inspect the retaining screws at times. If they are loose,
tighten them firmly.
11
Fix the camera firmly in position.
Peel off
the paper liner from the double-side adhesive tape
on the camera bracket and attach it. After attaching, push the
camera bracket with your finger to ensure close adhesion.
Do not touch the adhesive surface with your hand or peel and
reattach an attached tape, as these will degrade the adhesive
force and may cause the camera bracket to be detached. If
required, secure the bracket on the vehicle body using the
camera bracket clamping screw.
The camera bracket has two holes for the screw. Select one of
them to fit the position of the attachment.
Camera bracket clamping screw
(M3 x 8mm)