Kenwood CMOS-200 Instruction Manual - Page 6
Connections - cm 200
UPC - 019048189233
View all Kenwood CMOS-200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Connections Basic Connections Connect to the rearview camera video input or to the external video input of the video monitor. Power supply box Video cord: 1.5m (59.1 inch) Navigation system/video monitor (separately available) Camera connection cord Camera Connect the camera to the camera connection cord. Camera's cord length 5 m (197 inch), Camera connection cord length 3 m (118 inch) Switch unit (CMOS-300 only): 2 m (78.7 inch) CAMERA CAMERA Power cord When the monitor does not have the rearview camera input and switches the input upon detection, connect to vehicle's reverse lamp harness. Reverse detection cord (purple/white): 10 cm (3.94 inch) REVERSE Not used when connecting to a navigation system or monitor with a dedicated rearview camera video input. Engine key Fuse Accessory power (ACC) ACC Fuse (2A) 2A Accessory cord (Red): 1 m (39.4 inch) Connect to the ON-OFF switchable power supply. Do not connect to a permanently ON power supply. Main fuse - + Battery GND GND cord (Black): 1 m (39.4 inch) Connect to a metallic part of vehicle (a part of chassis connected to the negative side of power supply). CAUTION ɾIf the engine key of your vehicle does not have the ACC position, branch the wire energized when the engine key is ON and connect it to the accessory power cord. ɾBefore proceeding to connections, make sure that the engine key is not inserted and disconnect the (-) terminal of the battery to prevent the short-circuiting incident. 6 | CMOS-300/CMOS-200