Kenwood DNX7160 Installation Manual - Page 4

Connection Ignition key switch ACC ¤ If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box. Ignition wire (Red) Car fuse box (Main fuse) Car fuse box A Battery wire (Yellow) Ground wire (Black) (To car chassis) Antenna Cord FM/AM antenna input A Battery ⁄ Connect to the vehicle's parking brake detection switch harness. Parking sensor wire (Light Green) PRK SW For best safety, be sure to connect the parking sensor. Connect to vehicle's reverse lamp harness when using the optional rear view camera. To steering remote ⁄ To use the steering wheel remote control feature, you need to an exclusive remote adapter (not supplied) matched to your car is required. To car light control switch Connect to the terminal that is grounded when either the telephone rings or during conversation. ⁄ To connect the Kenwood navigation system, consult your navigation manual. Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type antenna. When using the optional power amplifier, connect to its power control terminal. ⁄ If no connections are made, do not let the cable come out from the tab. 4 DNX SERIES