Kenwood DPX-5000BT Operation Manual - Page 29

Wiring connection Rear/ Front/ Subwoofer output For 3-way crossover: Tweeter/ Mid Range/ Woofer output Fuse (10 A) IMPORTANT : We recommend installing the unit with a commercially available custom wiring harness specific for your car and leave this job to professionals for your safety. Consult your car audio dealer. When connecting to an external amplifier, connect its ground wire to the car's chassis to avoid damaging the unit. Part list for installation (A) Trim plate (only for Toyota car) Antenna terminal To front speaker (left) / For 3-way crossover: Mid range speaker (left) To front speaker (right) / For 3-way crossover: Mid range speaker (right) To rear speaker (left) / For 3-way crossover: Tweeter (left) To rear speaker (right) / For 3-way crossover: Tweeter (right) Ignition switch Car fuse box White White/Black Gray Gray/Black Green Green/Black Purple Purple/Black Red (Ignition wire) Car fuse box Battery Yellow (Battery wire) Black (Ground wire) To the metallic body or chassis of the car Microphone input jack ( 12) If no connections are made, do not let the wire come out from the tab. Brown (Mute control wire) To connect the Kenwood navigation system, refer your navigation manual (B) Wiring harness (C) Round head screws (M5 × 8 mm) Blue/White (Power control wire/ Antenna control wire) Light blue/yellow (Steering remote control wire) To the power control terminal when using the optional power amplifier or to the antenna control terminal in the vehicle (D) Flat head screws (M5 × 8 mm) To the steering wheel remote control adapter ENGLISH 29