Kenwood DPX504BT Quick Start Guide - Page 9
Part list
View all Kenwood DPX504BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Installing the unit (without mounting sleeve) 1 For / / : Remove the mounting sleeve and trim plate from the unit. 2 Align the holes in the unit (on both sides) with the vehicle mounting bracket and secure the unit with screws (supplied). (For / / / / ) (For ) Wiring connection Antenna terminal Use only the specified screws. Using wrong screws might damage the unit. Removing the unit (For / / ) Part list (Parts supplied for / / ) (A) Mounting sleeve (×1) (B) Trim plate (×1) (C) Trim plate (only for Toyota car) (×1) (D) Extraction key (×2) (Parts supplied for all models) (E) Round head screw (×6) (M5 × 8 mm) (F) Flat head screw (×6) (M5 × 8 mm) (G) Wiring harness (×1) Fuse (10 A) If no connections are made, do not let the wire come out from the tab. Car fuse box Ignition switch Car fuse box Battery a Brown: To connect the Kenwood navigation system, refer your navigation manual b Blue/white: To the power control terminal when using the optional power amplifier or to the antenna control terminal in the vehicle c Light blue/yellow: To the steering wheel remote control adapter d Red: Ignition 12 V e Yellow: Battery 12 V f Black: Ground g White ª, White/black ·: Front speaker (left) h Gray ª, Gray/black ·: Front speaker (right) i Green ª, Green/black ·: Rear speaker (left) j Purple ª, Purple/black ·: Rear speaker (right) 3