Kenwood KAC-X542 Instruction Manual - Page 4
Connection - fuse
UPC - 019048166906
View all Kenwood KAC-X542 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
901 01 901 01 901 01 01 Connection * Commercially available parts 2 WARNING To prevent fire caused by a short in the wiring, connect a fusible link or breaker nearby the battery's positive terminal. 2 CAUTION • If sound is not output normally, immediately turn power off and check connections. • Be sure to turn the power off before changing the setting of any switch. • If the fuse blows, check wires for shorts, then replace the fuse with one of the same rating. • Check that no unconnected wires or connectors are touching the car body. Do not remove caps from unconnected wires or connectors to prevent short circuits. • Connect the speaker wires to appropriate speaker connectors separately. Sharing the negative wire of the speaker or grounding speaker wires to the metal body of the car can cause this unit to fail. • After installation, check that the brake lamps, winkers, and wipers work properly. CENTER UNIT (CD receiver, etc.) Lead terminal* Power control wire FUSE(30A×2) POWER IN Terminal cover Battery wire* Protective Fuse* 789 30 30 RCA cable* RCA cable ground terminal GND B channel input A channel input 456 23 ID NUMBER TO H/U REMOTE RESET A channel Right speaker A channel Left speaker B channel Right speaker B channel Left speaker ■ Bridged Connections A channel Speaker (Bridged) Battery Ground wire* B channel Speaker (Bridged) ■ LX-Bus connection CENTER UNIT Power control wire 30 30 FUSE(30A×2) POWER IN Master amplifier Extension wire* To Kenwood disc changer/ External optional accessory Control cable (option) "0" 23 23 456 789 ID NUMBER TO H/U 456 78 ID NUMBER REMOTE RESET S-video cable* RCA cable* Set the ID number of the Master amplifier to "0". You can connect up to 7 Slave amplifiers. Assign them ID numbers "1" to "7" and do not duplicate them. 2 CAUTION • Do not connect 2 Master amplifiers to the Center Unit. If done, you cannot control all amplifiers connected to the Center Unit. • The LX AMP and the sensor unit cannot be connected simultaneously. You must connect any of them at a time. NOTE • The total length of S-video cables you can connect is 14 meters (46 ft) maximum. If the cable length exceeds this limit, you cannot control amps from the Center Unit. • If you assign the same ID number to multiple amplifiers, they malfunction when you operate any of them from the Center Unit. • If you assign ID number "8" or "9" to a Slave amplifier, it is not recognized by the Center Unit. 30 30 FUSE(30A×2) POWER IN Slave amplifier 1 456 23 23 789 ID NUMBER TO H/U 78 "1" - "7" 456 ID NUMBER REMOTE RESET Not more than 14m (46 ft) 30 30 FUSE(30A×2) POWER IN Slave amplifier 7 4 English 23 23 456 789 ID NUMBER TO H/U 78 456 "1" - "7" ID NUMBER REMOTE RESET