Kenwood KDC-348U Instruction Manual - Page 33
Installing the unit, Removing the unit - wiring
UPC - 019048193032
View all Kenwood KDC-348U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Installing the unit 1 3 Connect the wiring harness to the C unit. Other wiring connection has been completed earlier. (page 32) 2 1 B A 2 Before attaching, make sure the direction of the escutcheon is correct. (Wider hooks on the bottom side.) D 2 1 3 Dashboard of your car C 4 5 B Bend the appropriate tabs to hold the mounting sleeve firmly in place. A Installing without using the mounting sleeve (Japanese car) 1 Remove the mounting sleeve and escutcheon B from the unit. 2 Align the holes in the unit (on both sides) with the vehicle mounting bracket and secure the unit with the supplied screws. T N NT T/N B 8 mm MAX. F ø5mm 8mm MAX. G ø5mm T: Toyota cars N: Nissan cars Removing the unit 1 Detach the faceplate A. 2 Engage the catch pin on the removal tools E into the holes on both sides of the escutcheon B, then pull it out. 3 Insert the removal tools E deeply into the slots on each side, then follow the arrows instructions as shown on the right. E B 12 A E C 3 English 33