Kenwood TK-2200LV8P Instruction Manual - Page 21

GETTING STARTED 1 1 Turn the Power switch/ Volume control clockwise to switch the transceiver power ON. A beep sounds. 2 1 Rotate the Channel selector to select your desired channel. When you receive an appropriate signal, you will hear audio from the speaker. Adjust the volume as necessary. To make a call, press and hold the PTT switch, then speak into the microphone to transmit. Release the PTT switch to receive. 3 The LED lights red while transmitting. For best sound quality, speak into the microphone in your normal voice while holding the microphone approximately 1.5 inches (3 to 4 cm) from your lips. ■ Channel Selector Scan Position (TK-3200L (K3) model only) Scan is useful for monitoring signals on the transceiver channels. When scanning, the transceiver checks for a signal on each channel and only stops if a signal is present. For further details on how scan operates, refer to "Scan" on page 35. 5 9 7 Rotate the Channel selector and select the 11 "S" position to begin scanning. The LED indicator flashes green and scanning 13 starts from the current channel and ascends through the channel numbers. 15 1 S During Scan, to stop scanning, rotate the Channel selector to any position other than the "S" position. 3 13