KitchenAid KBBR306EPA Installation Guide - Page 19
Install Overlay Series Custom Panels
View all KitchenAid KBBR306EPA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
1. Use a socket driver to turn the leveling bolts clockwise to extend the legs to the floor as shown. The rollers should be off the floor. A AB B A. Rear leveling bolt B. Front leveling bolt 2. Adjust the leveling legs to level and align the refrigerator from left to right and front to back so that the refrigerator is level and aligned with the cabinetry. The cabinetry surface must be plumb for the ideal fit of the refrigerator side trim. 3. Continue adjusting all of the leveling legs to raise the refrigerator until the top is within at least 1" (2.54 cm) of the top soffit. NOTE: If an anti-tip board has been used, adjust the leveling legs until the top of the refrigerator is within ¹⁄₄" (6.35 mm) of the bottom of the anti-tip board as shown. Do not crush the compressor cover. A B Install Overlay Series Custom Panels IMPORTANT: ■ Install the custom handles prior to installing the panels on the refrigerator. For more information on KitchenAid custom handle selection, refer to the KitchenAid Catalog, visit www.kitchenaid.com, or call 1-800-442-9991. In Canada, visit www.KitchenAid.ca, or call 1-800-807-6777. ■ Create custom door overlay panels according to the specifications in the "Overlay Series Custom Panels" section. ■ KitchenAid is not responsible for the removal or addition of molding or decorative panels that would not allow access to the refrigerator for service. Door Panel Installation 1. Remove all tape and door bracing from the refrigerator and freezer doors. 2. Open the refrigerator and freezer compartment doors. 3. Remove the handle-side and top trims. A A 2" (5 cm) C ¹⁄₄" (6 mm) max. D A. Center board ¹⁄₄" (6.35 mm) max. above refrigerator B. 2" x 4" x 32" (5 cm x 10 cm x 81 cm) boards (2) C. Attach to studs with six #8 x 3" (7.6 cm) screws D. Compressor cover IMPORTANT: Adjust in small increments to keep from damaging the cabinet trim and causing problems with the door alignment or top grille fit. To avoid damage to the cabinet or leveling legs, do not apply more than 50 inch-pounds (5.65 Nm) of torque to the leveling bolts. The leveling legs can be extended to a maximum of 1¹⁄₄" (3.18 cm) below the rollers. 4. For Overlay models, additional adjustments may be needed after the custom panels are installed. A. Trims 4. Slide the custom panels into the bottom and hinge side trims on the refrigerator compartment and freezer compartment doors, making sure that the backer panel fits into the hinge side trims. A A A. Panels 19