KitchenAid KBHS109BSS Dimension Guide - Page 1

27" (68.6 cm) and 30" (76.2 CM) ELECTRIC BUILT-IN CONVECTION MICROWAVE OVEN PRODUCT MODEL SERIES CABINET DIMENSIONS KBHS109B KBHS179B ELECTRICAL CONNECTION q Microwave oven must be connected to the proper electrical voltage and frequency as specified on the model/serial number rating plate. The model/serial number rating plate is located underneath the control panel, along the oven vent. 27" (68.6 cm) and 30" (76.2 cm) Microwave Ovens A A D F B G A. Model/serial number plate q The microwave oven rated 120/240 volt, 20-amp, has 4 wires (L1, L2, N and G) in the flex conduit and should be connected to a 20-amp maximum rated circuit, overcurrent protected on both the L1 and L2 circuits. q A time-delay fuse or circuit breaker is recommended. PRODUCT DIMENSIONS 27" (68.6 cm) and 30" (76.2 cm) Microwave Ovens A B E D C 27" (68.6 cm) models A. 25⁵⁄₈" (65.1 cm) recessed width B. 18⁵⁄₈" (47.3 cm) overall height C. 26³⁄₄" (68.0 cm) overall width D. 22³⁄₄" (57.8 cm) overall depth E. 17¹⁄₄" (43.8 cm) recessed height 30" (76.2 cm) models A. 25⁵⁄₈" (72.7 cm) recessed width B. 18⁵⁄₈" (47.3 cm) overall height C. 29³⁄₄" (75.6 cm) overall width D. 22³⁄₄" (57.8 cm) overall depth E. 17¹⁄₄" (43.8 cm) recessed height 27" (68.6 cm) and 30" (76.2 cm) Microwave Oven Spacer Kit E C 27" (68.6 cm) models A. 27" (68.6 cm) min. cabinet width B. 18⁵⁄₈" (47.3cm) from bottom of cutout to bottom of upper cabinet door C. 40" (101.6 cm) bottom of cutout to floor (recommended) D. 25¹⁄₂" (64.8 cm) cutout width E. 1¹⁄₂" (3.8 cm) min. bottom of cutout to top of cabinet door F. 17⁵⁄₈" (44.7 cm) recommended cutout height (will fit cutout height from 17³⁄₈" [44.1 cm] to 17³⁄₄" [45.1 cm]) G. 21⁷⁄₈" (55.5 cm) min. cutout depth 30" (76.2 cm) models A. 30" (76.2 cm) min. cabinet width B. 18⁵⁄₈" (47.3cm) from bottom of cutout to bottom of upper cabinet door C. 40" (101.6 cm) bottom of cutout to floor (recommended) D. 28¹⁄₂" (72.4 cm) cutout width E. 1¹⁄₂" (3.8 cm) min. bottom of cutout to top of cabinet door F. 17⁵⁄₈" (44.7 cm) recommended cutout height (will fit cutout height from 17³⁄₈" [44.1 cm] to 17³⁄₄" [45.1 cm]) G. 21⁷⁄₈" (55.5 cm) min. cutout depth MINIMUM INSTALLATION CLEARANCES For proper installation, the following minimum clearances must exist above and below the cabinet opening. Installation Above Single Built-In Oven A 1" (2.5 cm) A 27" (68.6 cm) models A. 26³⁄₄" (67.9 cm) overall width 30" (76.2 cm) models A. 29³⁄₄" (75.6 cm) overall width NOTE: The microwave oven spacer kit will allow the microwave oven to be installed in a 17³⁄₈"-17³⁄₄" (44.1-45.1 cm) maximum cutout height. A microwave oven spacer kit is available from your dealer that will allow the microwave oven to be installed in a 19"-19 48.3-50.2 cm) maximum cutout height. Match the oven size to the following kits: 27" (68.6 cm) Stainless Steel - Model W10469901 30" (76.2 cm) Stainless Steel - Model W10469903 To order, see the "Assistance or Service" section of the Use and Care Guide. 1" (2.5 cm) from top of oven B A. Upper cabinet B. Lower single oven Approved models: KEBK171B, KEBK101B, KEBS179B, KEBS109B and KEBU109B. Because Whirlpool Corporation policy includes a continuous commitment to improve Dimensions are for planning purposes only. For complete details, see Installation our products, we reserve the right to change materials and specifications without notice. Instructions packed with product. Specifications subject to change without notice. Ref. W10351317A 9/17/12