KitchenAid KBLS36FTX Installation Guide - Page 26
Door Swing Adjustment, 91.4 cm Models, 106.7 cm Models
View all KitchenAid KBLS36FTX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Door Swing Adjustment 4. The door stop is located on the top hinge. 36" (91.4 cm) Models 1. Check that the refrigerator door can open freely. If the door opens too wide, remove the door stop screw from the bottom hinge with a Torx®† T15 screwdriver. A B C A A. Door stop screw 2. Hold the door open to a position that is less than 90°. 3. Replace the door stop screw in the bottom hinge and tighten. IMPORTANT: Do not place the door stop screw in the 130° position on Overlay Series models. See "Handle and Door Clearances." A. Door stop screw "A" B. Door stop screw "B" C. Door stop 5. Remove the 2 door stop screws. ■ To remove the outer screw ("A"): With the door closed, firmly press the L-shaped bracket towards the center of the refrigerator until the screw is exposed. ■ To remove the inner screw ("B"): Open the door 90° and the L-shaped bracket will expose the screw. AB C A. 130° B. 110° (Overlay series) C. 90° 42" (106.7 cm) Models 1. Check that the refrigerator door can open freely. If the door opens too wide, you will have to adjust the door stop position. 2. Grasp both ends of the top grille. 3. Push the top grille straight up; then pull straight out. Lay the grille on a soft surface. B A B A B A. Door stop screw "A" B. Door stop screw "B" 6. Reverse or rotate the door stop to the desired position as shown below. A. Top grille B. Cabinet side trims †®TORX is a registered trademark of Textron Innovations Inc. 26