KitchenAid KDTE234GPS Panel Install Instructions - Page 2

WARNING Excessive Weight Hazard Use two or more people to move and install dishwasher. Failure to do so can result in back or other injury. Using 2 or more people, stand the dishwasher up. NOTE: Do not install kick plate until instructed to do so. Using the template provided, attach it to the backside of the custom panel with tape. Make sure that the center of the template is aligned with the center of the wooden panel and top of the template is aligned to the top face of the wooden panel. Install the custom hardware handle(s) on the front of the wooden panel inside dotted line. IMPORTANT: If the handle is attached from the back of the custom panel, the screw holes should be countersunk for the screws heads to be flush with the panel. If the handle is attached to the front of the custom panel, the screw lengths cannot exceed the panel thickness. NOTE: Do not drill deeper then 16 mm) to keep from drilling through panel. Pilot hole depths given are for ³⁄₄" (19 mm) thick panel. Mark 4 pilot holes on the wooden panel using the template provided. Pre-drill 4 pilot holes using a drill bit. Use tape to mark the drill bit to gauge hole depth. Drill pilot holes approximately 16 mm) into the custom panel. Attach the 4 plastic studs to the wooden panel using the four hex-head (short) screws provided. 2