KitchenAid KESS907SWW Use and Care Manual - Page 21

Oven Vent, Positioning Racks and Bakeware

Page 21 highlights

3. Press START. The set oven temperature will appear on the oven display throughout cooking. "Lo" will appear as the probe temperature until the internal temperature of the food reaches 130°F (54°C) or if the probe is unplugged. Then the display will show the temperature increasing in 1°F increments. When the set probe temperature is reached, the oven will shut off automatically and "Cooking Complete" will appear on the oven display. If enabled, end-of-cycle tones will sound. 4. Press OFF or open the oven door to clear the display. To Change Probe Temperature, Oven Setting: Press OFF, then repeat previous steps. After cooking, unplug the probe and remove food from oven. The probe symbol will remain lit until the probe is unplugged from the probe jack. See "General Cleaning" section to clean probe. Oven Vent A A. Oven vent The oven vent should not be blocked or covered since it allows the release of hot air and moisture from the oven. Blocking or covering the vent will cause poor air circulation, affecting cooking and cleaning results. Do not set plastics, paper or other items that could melt or burn near the oven vent. Positioning Racks and Bakeware IMPORTANT: To avoid permanent damage to the porcelain finish, do not place food or bakeware directly on the oven door or bottom. RACKS ■ Position racks before turning on the oven. ■ Do not position racks with bakeware on them. ■ Make sure racks are level. To move a rack, pull it out to the stop position, raise the front edge, and then lift out. Use the following illustration and charts as a guide. 5 4 3 2 1 Traditional Cooking FOOD RACK POSITION Large roasts, turkeys, angel food, bundt and tube cakes, quick breads, pies 1 or 2 Yeast breads, casseroles, meat and 2 poultry Cookies, biscuits, muffins, cakes 2 or 3 Convection Cooking FUNCTION NUMBER OF RACK RACKS USED POSITION(S) Convection baking or 1 roasting 1, 2 or 3 Convection baking 2 2 and 4 Convection baking 3 1, 3 and 5 BAKEWARE To cook food evenly, hot air must be able to circulate. Allow 2" (5 cm) of space around bakeware and oven walls. Use the following chart as a guide. NUMBER POSITION ON RACK OF PAN(S) 1 Center of rack. 2 Side by side or slightly staggered. 3 or 4 Opposite corners on each rack. Make sure that no bakeware piece is directly over another. Bake The BAKE function is ideal for baking, roasting or heating foods. During baking or roasting, the bake and broil elements will cycle on and off in intervals to maintain oven temperature. If the oven door is opened during baking or roasting, the broil element will turn off immediately and the bake element will turn off in 30 seconds to 2 minutes. They will come back on once the door is closed. To Bake or Roast: Before baking and roasting, position racks according to the "Positioning Racks and Bakeware" section. For baking, allow the range to preheat before placing food in the oven. When roasting, it is not necessary to wait for the oven to preheat before putting food in, unless recommended in the recipe. 1. Press BAKE once for 350°F (177°C), or press the number pads to enter the desired temperature. 2. Press START. "Preheating" will show in the display until the set temperature is reached. "Lo" will also appear in the display if the actual oven temperature is under 170°F (77°C). When the actual oven temperature reaches 170°F (77°C), the oven display will show the oven temperature increasing in 1-degree increments. When the set temperature is reached, if on, 1 tone will sound. 3. Press OFF when finished cooking. 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32

21
3.
Press START.
The set oven temperature will appear on the oven display
throughout cooking.
“Lo” will appear as the probe temperature until the internal
temperature of the food reaches 130°F (54°C) or if the probe
is unplugged. Then the display will show the temperature
increasing in 1°F increments.
When the set probe temperature is reached, the oven will
shut off automatically and “Cooking Complete” will appear on
the oven display.
If enabled, end-of-cycle tones will sound.
4.
Press OFF or open the oven door to clear the display.
To Change Probe Temperature, Oven Setting:
Press OFF, then repeat previous steps.
After cooking, unplug the probe and remove food from oven. The
probe symbol will remain lit until the probe is unplugged from the
probe jack.
See “General Cleaning” section to clean probe.
Oven Vent
The oven vent should not be blocked or covered since it allows
the release of hot air and moisture from the oven. Blocking or
covering the vent will cause poor air circulation, affecting cooking
and cleaning results. Do not set plastics, paper or other items
that could melt or burn near the oven vent.
Positioning Racks and Bakeware
IMPORTANT:
To avoid permanent damage to the porcelain
finish, do not place food or bakeware directly on the oven door or
bottom.
RACKS
Position racks before turning on the oven.
Do not position racks with bakeware on them.
Make sure racks are level.
To move a rack, pull it out to the stop position, raise the front
edge, and then lift out. Use the following illustration and charts as
a guide.
Traditional Cooking
Convection Cooking
BAKEWARE
To cook food evenly, hot air must be able to circulate. Allow
2" (5 cm) of space around bakeware and oven walls. Use the
following chart as a guide.
Bake
The BAKE function is ideal for baking, roasting or heating foods.
During baking or roasting, the bake and broil elements will cycle
on and off in intervals to maintain oven temperature.
If the oven door is opened during baking or roasting, the broil
element will turn off immediately and the bake element will turn
off in 30 seconds to 2 minutes. They will come back on once the
door is closed.
To Bake or Roast:
Before baking and roasting,
position racks according to the
“Positioning Racks and Bakeware” section.
For baking, allow the range to preheat before placing food in the
oven. When roasting, it is not necessary to wait for the oven to
preheat before putting food in, unless recommended in the
recipe.
1.
Press BAKE once for 350°F (177°C), or press the number
pads to enter the desired temperature.
2.
Press START.
“Preheating” will show in the display until the set temperature
is reached.
“Lo” will also appear in the display if the actual oven
temperature is under 170°F (77°C).
When the actual oven temperature reaches 170°F (77°C), the
oven display will show the oven temperature increasing in
1-degree increments.
When the set temperature is reached, if on, 1 tone will sound.
3.
Press OFF when finished cooking.
A. Oven vent
A
1
2
3
4
5
FOOD
RACK POSITION
Large roasts, turkeys, angel food,
bundt and tube cakes, quick
breads, pies
1 or 2
Yeast breads, casseroles, meat and
poultry
2
Cookies, biscuits, muffins, cakes
2 or 3
FUNCTION
NUMBER OF
RACKS USED
RACK
POSITION(S)
Convection baking or
roasting
1
1, 2 or 3
Convection baking
2
2 and 4
Convection baking
3
1, 3 and 5
NUMBER
OF PAN(S)
POSITION ON RACK
1
Center of rack.
2
Side by side or slightly staggered.
3 or 4
Opposite corners on each rack. Make sure that
no bakeware piece is directly over another.