KitchenAid KESS907SWW Installation Instructions - Page 10

4. Drill two ¹⁄₈" (3 mm) holes that correspond to the bracket holes of the determined mounting method. See the following illustrations. Floor Mounting 5. Using a Phillips screwdriver, mount the anti-tip bracket to the wall or floor with two #12 x 1⁵⁄₈" screws provided. 6. Move the range close enough to the opening to allow for final gas and electrical connections. Remove the shipping base, cardboard or hardboard from under the range. 7. Move the range into its final location, making sure the rear leveling leg slides into the anti-tip bracket. Rear position Wall Mounting Front position Diagonal (2 options) 8. Move the range forward onto shipping base, cardboard or hardboard to continue installing the range using the following installation instructions. Power Supply Cord Electrical Connection - U.S.A. Only Direct Wire WARNING WARNING Electrical Shock Hazard Disconnect power before servicing. Use a new 40 amp power supply cord. Plug into a grounded outlet. Failure to follow these instructions can result in death, fire, or electrical shock. Electrical Shock Hazard Disconnect power before servicing. Use 8 gauge copper or 6 gauge aluminum wire. Electrically ground range. Failure to follow these instructions can result in death, fire, or electrical shock. 1. Disconnect power. 2. Remove the terminal block cover screws located on the back of the range. Pull cover down and toward you to remove cover. 3. Remove plastic tag holding three 10-32 hex nuts from the middle post of the terminal block. A B A. Hold-down screws B. Terminal block cover 10 4. Add strain relief.