KitchenAid KFIS20XVMS Use & Care Guide - Page 6
Replace Doors and Hinges, Remove and Replace Freezer Drawer, Remove Drawer Front, Replace Drawer - parts
UPC - 883049135427
View all KitchenAid KFIS20XVMS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
3. Starting with the right-hand side door, remove the parts for the top hinge as shown in Top Hinge graphic. Lift the refrigerator door from the bottom hinge pin. 4. Remove the shim from the bottom hinge pin and keep it for later use. See Bottom Hinge graphic. 5. Remove top hinge cover from left side refrigerator door. Disconnect the wiring plug located on top of the hinge by wedging a flat-blade screwdriver or your fingernail between the two sections. See Connections graphic. 6. Disconnect the water line by pulling back on the locking collar while pulling the water line out of the water line connector. See Connections graphic. 7. Remove the parts for the top hinge as shown in Top Hinge graphic. Lift the left-hand side door from the bottom hinge pin. NOTE: On some models, remove the shim from the bottom hinge pin and keep it for later use. See Bottom Hinge graphic. 8. Using a ³⁄₈" hex wrench, remove the leveling leg brackets from the bottom of the cabinet. Keep screws for later use. Replace Doors and Hinges 1. Assemble the parts for the top hinge as shown in Top Hinge graphic. Do not tighten the screws completely. 2. Replace the parts for the bottom hinge as shown in Bottom Hinge graphic. Tighten screws. Replace the refrigerator door. NOTE: Provide additional support for the refrigerator door while the hinges are being moved. Do not depend on the door gasket magnets to hold the door in place while you are working. 3. Align the door so that the bottom of the refrigerator door aligns evenly with the top of the freezer drawer. Tighten all screws. 4. Reconnect the wiring plug on top of the left-hand side refrigerator door. 5. Reconnect the water line by pulling back the locking collar ring while firmly pushing the water line into the connector. 6. Check for leaks. Replace the top hinge covers. Remove and Replace Freezer Drawer IMPORTANT: Two people may be required to remove and replace the freezer drawer. Graphics are included later in this section. Remove Drawer Front 1. Open the freezer drawer to full extension. 2. Loosen the four screws attaching the drawer glides to the drawer front. See Drawer Front Removal graphic. NOTE: Loosen screws three to four turns. Keep the screws in the drawer front. 3. Lift drawer front upward and off the screws. See Drawer Front Removal graphic. Replace Drawer Front 1. Slide the drawer glides out of the freezer compartment. Insert the screws in the top of the drawer front into the slots in the drawer brackets. See Drawer Front Replacement graphic. 2. Pull the drawer brackets toward you to position the two screws in the bottom of the drawer front into the brackets. See Drawer Front Replacement graphic. 3. Completely tighten the four screws. Final Steps WARNING Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 1. Plug into a grounded 3 prong outlet. 2. Return all removable parts to doors and drawer and food to refrigerator and freezer. 6