KitchenAid KHHS179LBL Installation Instructions - Page 11

6. If adjustment is required, rotate microwave oven downward. Using 2 or more people, lift microwave oven off of mounting plate, and set aside on a protected surface. For Roof Venting Installation Only 1. Insert damper assembly through the cabinet cutout so that the long tab of the damper assembly slides under the raised tabs of the damper plate. Then secure with screw removed in Step 1 of "Rotate Air Deflector." NOTE: The screw cannot be installed if the damper assembly is not positioned as shown. A B C 7. Loosen mounting plate screws. Adjust mounting plate and retighten screws. 8. Repeat steps 3-5. 9. With the microwave oven centered, and with at least one person holding it in place, insert bolts through upper cabinet into microwave oven. Tighten bolts until there is no gap between upper cabinet and microwave oven. NOTES: ■ Some upper cabinets may require bolts longer or shorter than 3" (7.6 cm). Longer or shorter bolts are available at most hardware stores. ■ Overtightening bolts may warp the top of the microwave oven. To avoid warping, wood filler blocks may be added. The blocks must be the same thickness as the space between the upper cabinet bottom and the microwave oven. A D E F A. Raised tabs B. Damper assembly C. Screw D. Upper cabinet cutout E. Long tab F. Damper plate 2. Connect vent to damper assembly. A B A. Bolts A. Vent B. Damper assembly (under vent) 11