KitchenAid KHMS2050SBT Installation Instructions - Page 4
Installation Instructions - attachments
UPC - 883049023939
View all KitchenAid KHMS2050SBT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
INSTALLATION INSTRUCTIONS Remove Mounting Plate NOTE: To avoid possible damage to the work surface, place a protective cover on the work surface. 1. Remove any remaining contents from the oven cavity. 2. Remove the mounting plate by peeling off the strips of tape that attach it to the back of the oven, and set the mounting plate aside. Convert Oven to External Venting (for wall or roof venting only) The oven is set for recirculation installation. For wall or roof venting, changes must be made to the venting system. See "Venting Design Specifications" section. NOTE: Skip this section if you are using recirculation installation. Keep the damper assembly in case the venting method is changed, or the oven is reinstalled in another location where wall or roof venting may be used. To prepare the oven for wall or roof venting, the vent deflector (Lshaped metal bar) must be installed, and the appropriate damper vent opening must be uncovered. To Install Vent Deflector: 1. Gently pull the rings and lift vent screen from the top of the oven. A A B C A. Mounting plate B. Back of oven C. Tape (multiple locations) 3. Tape the oven door closed so that door does not swing open while the oven is being handled. NOTE: Do not grip or use the door or door handle while the oven is being handled. B C A. Top of oven B. Vent screen C. Rings 2. With vent deflector oriented as shown (wide side down), slide it back and under the back edge of the vent opening. A B A. Vent opening B. Vent deflector 4