KitchenAid KSGG700ESS Installation Instructions - Page 21
To Convert Oven Broil Burner Propane Gas to Natural, Gas on some models
View all KitchenAid KSGG700ESS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
3. Lift the rear of the oven bottom up and back until the front of the panel is away from the front frame. Remove from oven and set it aside on a covered surface. A B 7. Replace the "56" spud with a "47" spud. Install the Natural gas bake burner orifice spud, turning it clockwise until snug. IMPORTANT: Do not overtighten. A A. Screws B. Oven bottom 4. Remove 2 screws from the bake burner. 5. Slide the front of the bake burner to the side to remove tab from front of oven. Lift the back of the bake burner off the oven orifice, and set the bake burner aside. Do not disconnect the wire. A B A. Bake burner B. Screws A A. Orifice spud 8. Position the back of the bake burner over the oven orifice, and then align the holes for the screws. 9. Reattach the bake burner with 2 screws. 10. Position the front of the oven bottom panel toward the front frame, and then lower the rear of the oven bottom panel into the oven. 11. Reattach the oven bottom panel with 2 screws and 2 washers. To Convert Oven Broil Burner (Propane Gas to Natural Gas) (on some models) 1. Remove 1 screw from the broil burner. 2. Remove the flame spreader. 3. Remove the broil burner from the broil burner orifice hood. NOTE: The broil burner will hang in the back of the oven while you are changing the orifice hood. A C B A. Oven orifice 6. Apply masking tape to the end of a 3/8" (1 cm) nut driver to help hold the gas orifice spud in the nut driver while changing it. Press nut driver down onto the gas orifice spud and remove by turning the Propane gas bake burner orifice spud counterclockwise to remove. The spud will be stamped with a "56". D A. Broil burner B. Flame spreader C. Screws D. Orifice hood 4. Apply masking tape to the end of a 3/8" (1 cm) nut driver to help hold the gas orifice spud in the nut driver while changing it. Press nut driver down onto the gas orifice spud and remove by turning the Propane gas broil burner orifice hood counterclockwise to remove. The hood will be stamped with a "100". 21