KitchenAid KSSC42FTS Installation Guide - Page 23
Install Classic Series Custom Panels, Install Overlay Series Custom Panels - kitchenaide
UPC - 883049037967
View all KitchenAid KSSC42FTS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Install Classic Series Custom Panels IMPORTANT: KitchenAid is not responsible for the removal or addition of molding or decorative panels that would not allow access to the refrigerator for service. Door Panels 1. Remove all tape and door bracing from the refrigerator and freezer doors. 2. Remove the screws that attach the handles to the door frame. 3. Slide the decorative door panels into the door frames. 4. If needed, route the door panels or install a filler panel between the doors and the decorative panels. See the "Classic Series Custom Panels" section in "Installation Requirements." 3. Remove one end cap by loosening the nuts and sliding off the end cap. A C B D A. Bottom rail B. Nuts C. End cap D. Top rail 4. Slide the backer panel into the top grille channel and reattach the end cap. A A A A. Backer panel 5. Replace the top grille in the cabinet side trims and pull the panel down slightly to lock it into place. B A B A. Panels 5. Replace the door handles. Install the top screw on each handle first. Be sure that the top of both door handles are aligned. 6. If the door handles are not aligned, loosen all handle screws and adjust door handles up or down. Tighten the screws. 7. Check refrigerator level and adjustment. Adjust if needed. Top Grille Panel 1. Grasp both ends of the top grille. 2. Push straight up, then pull straight out. Place the top grille panel-side down on a soft working surface. B A B A. Top grille B. Cabinet side trim A. Top grille B. Cabinet side trim Install Overlay Series Custom Panels IMPORTANT: ■ Install the custom handles prior to installing the panels on the refrigerator. For more information on KitchenAid custom handle selection, refer to the KitchenAid Catalog, visit www.kitchenaid.com, or call 1-800-442-9991. In Canada, visit www.KitchenAid.ca, or call 1-800-807-6777. ■ Create custom door overlay panels according to the specifications in the "Overlay Series Custom Panels" section. ■ KitchenAid is not responsible for the removal or addition of molding or decorative panels that would not allow access to the refrigerator for service. Door Panel Installation 1. Remove all tape and door bracing from the refrigerator and freezer doors. 2. Open the refrigerator and freezer compartment doors. 23