KitchenAid KUDC03IVBS Installation Instructions - Page 16

3 Mark line Back " (25.2 cm) Top edge Measure 9 25.2 cm) from top edge and mark a line on the back of customer-supplied custom panel. Position the outer panel on the back of the customer-supplied custom panel as shown, so that the top holes in the outer panel are on the line, and both panels are centered side to side. 4 Mark pilot holes Mark pilot holes Mark all four hole locations; remove outer panel. Drill pilot holes ¹⁄₂" (13 mm) deep in customer-supplied custom panel. Place the outer panel on the back of the customer- supplied custom panel; align holes. 5 Attach handle 6" (15.2 mm) Hex Head Screw Attach outer panel to back of customer-supplied custom panel with the four #10-16 x ³⁄₈" hex head screws supplied in the literature package. Attach the handle. The handle should be centered on the front of the customer-supplied custom panel in the area shown. IMPORTANT: Screw heads must be flush with back of customer-supplied custom panel. 16 6 Attach body panel Reinstall 3 screws each side Align top edges Customer-supplied panel Attach the panel assembly to the door by reinstalling the three screws on each side; do not tighten completely. This reinstallation of the three screws will hold the panel assembly in place on the door frame. 7 Install custom panel Align top edges Customer-supplied panel Drill through these holes Align the top edge of the customer-supplied custom panel with the top of the console. Drill two pilot holes ¹⁄₂" (13 mm) deep, into the customer-supplied custom panel, through the holes in the top corners on the inner panel, as shown. 8 Install custom panel Align top edges Drill through these holes Customer-supplied panel 1³⁄₈" Screw Install the two #8-18 x 1³⁄₈" screws from the literature package in the top corners of the inner panel. Tighten the six side screws reinstalled in Step 6.