KitchenAid KUDS30SXSS Installation Guide - Page 22
Connect to Drain, Make Direct Wire Electrical
View all KitchenAid KUDS30SXSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Connect to Drain Place towel under drain hose to catch any water in drain hose. Place the small green drain hose clamp onto the small end of the drain hose. Push the new drain hose into the black drain hose connector up to the drain hose stop. After hose is connected, remove towel. If needed, see website for animated representation of this step. Visit www.kitchenaid.com/drain under FAQ tab. Make Direct Wire Electrical NOTE: If the power supply cord was connected earlier, proceed to "Secure Dishwasher in Cabinet Opening" section. Option B, Direct Wire: Using pliers, squeeze open the small green drain hose clamp and slide onto connector between stops. Route cable so that it does not touch dishwasher motor or lower part of dishwasher tub. Pull cable through UL Listed/CSA Approved strain relief in terminal box. Strain relief is not supplied with the dishwasher. Owner must purchase a ⁷⁄₈" screw-in type strain relief. Select UL Listed/CSA Approved twist-on wire connectors (not included) rated to connect your household wiring to 16-gauge dishwasher wiring. 22