KitchenAid KUDU03FTPA Installation Instructions - Page 17
Connect to water supply
View all KitchenAid KUDU03FTPA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
3. Connect the wires as follows using twist-on connectors sized to connect direct wire to 16-gauge dishwasher wire: Power supply wire: white black ground wire Terminal box wire: white black ground connector Option 2: Power supply cord method WARNING WARNING Electrical Shock Hazard Electrically ground dishwasher. Connect ground wire to green ground connector in terminal box. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 4. Form bare ground wire into a U-shaped hook. Wrap ground wire hook clockwise around ground connector and under the washer. 5. Securely tighten ground connector. ground wire washer ground connector ground wire 6. Tighten clamp connector or conduit connector screws. screws Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 1. Plug into a grounded 3 prong outlet. 2. Check that power supply cord does not touch dishwasher motor or lower part of dishwasher tub. Connect to water supply Helpful Tip: Compression fittings: a. Slide nut onto copper tubing about 1" (2.5 cm). b. Slide ferrule onto the tubing. Do not position ferrule on the end of the tubing. c. Put the tubing into the elbow as far as it will go. d. Slide the nut and ferrule forward and start the nut onto the elbow threads. Be gentle when handling and positioning the copper tubing, it bends and kinks easily. nut ferrule elbow 7. Reinstall terminal box cover with wires inside terminal box. The cover must be outside the box on the left side. ADVERTENCIA AVERTISSEMENT 1. To prevent vibration during operation, route the water supply line so that it does not touch the dishwasher base, frame or motor. 2. With copper tubing pushed into compression fitting as far as it will go, use a wrench and tighten compression fitting nut to elbow on water inlet valve. 8. Make sure no wires are pinched by cover. 3. Place paper towel under elbow. Turn on water supply and check for leaks. 17