KitchenAid KUID508HWH Owners Manual - Page 7
Performance Data Sheet
View all KitchenAid KUID508HWH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
PERFORMANCE DATA SHEET Ice Maker Water Filtration System Model P6GEG2KL, P6KG2KL, P6WG2KL Capacity 2000 Gallons (7571 Liters) System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor. This system has been tested according to NSF/ANSI Standards 42 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI Standards 42. Substance Reduction Aesthetic Effects NSF Reduction Requirements Average Influent Influent Challenge Maximum Concentration Effluent Average Effluent Minimum % Average % Reduction Reduction Chlorine Taste/Odor 50% reduction 1.9727 mg/L 2.0 mg/L ± 10% 0.71 mg/L 0.7788 mg/L 70.2 Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.50 gpm (1.89 Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 68°F to 71.6°F (20°C to 22°C). Rated service capacity = 2000 gallons (7571 liters). 72.81 ■■ It is essential that operational, maintenance, and filter replacement requirements be carried out for the product to perform as advertised. ■■ Use replacement filter P6RFWG2K, P6RFGEG2K, P6RFKG2K, Part Number ICE2. Style 1 - When the water filter status display changes from "GOOD" to "ORDER," order a new filter. When the filter indicator reads "REPLACE," it is recommended that you replace the filter. Style 2 - Press FILTER to check the status of your water filter. If the filter indicator light is yellow and the words "ORDER FILTER" appear on the display screen, order a new filter. If the filter indicator light is red, it is recommended that you replace the filter. ■■ These contaminants are not necessarily in your water supply. While testing was performed under standard laboratory conditions, actual performance may vary. ■■ The product is for cold water use only. ■■ Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. ■■ Refer to the "Warranty" section for the Manufacturer's name, address and telephone number. ■■ Refer to the "Warranty" section for the Manufacturer's limited warranty. Application Guidelines/Water Supply Parameters Water Supply City or Well Water Pressure 30 - 120 psi (207 - 827 kPa) Water Temperature 33°- 100°F (0.6° - 37.8°C) Service Flow Rate 0. 50 gpm (1.89 Lpm) @ 60 psi ®NSF is a registered trademark of NSF International. 7