Kodak 8461444 Setup Guide

CIS-256

June 2004

•

Make sure “0” is aligned with the arrow in the

frame-counter window.

•

If the “0” is not aligned, grip the camera and

cover the lens.Then press the

shutter button

and turn the

thumbwheel

(repeat these steps

until the film is fully rewound).

The film is fully rewound when the

thumb-

wheel

rotates freely and does not stop or lock.

•

Insert the special tool into the end slot.

•

Using the special tool, hold the camera firmly

and pull upwards to break off the film door

and to remove the film.

• Place the used camera in the

Kodak recycle bin.

• Visit our Web site at

http://

www.kodak.com/go/kes

for details

about Kodak’s recycling program.

• Call Kodak’s advertising distribution

center at (800) 847-8755 to order

a Kodak hand-opening tool.

CAUTION: Before you attempt the

opening tasks, make sure the tool is

fully engaged with the camera body to

prevent tool slippage.

CAUTION: This camera body contains

a high-voltage capacitor and circuit

board. To avoid electric shock, do not

pry apart the front and back sections

of the camera. Remove only the film

from its respective compartment. If

sections of the camera are separated,

do not touch the circuit board.

© Eastman Kodak Company, 2004

5

CURRENT INFORMA

TION SUMMAR

Y

Opening Instructions for the

KODAK Zoom One-Time-Use Camera

Wear eye protection when opening all cameras.

Wind Off

0

shutter button

thumbwheel

1

Insert Tool

2

Break Off Film Door

3

Remove Film

Exposed

Film

Opened camera

with film removed.

4

Kodak 8461444 Setup Guide

Kodak 8461444 - Max Flash Camera One Time Use Manual

Kodak 8461444 manual content summary: