Kodak C330 User Manual - Page 51

Camera ready light status - zoom

Page 51 highlights

Troubleshooting If... Try one or more of the following Picture is too light I Reposition camera to reduce the amount of available light. I Turn flash off (page 26). I Move so that the distance between you and the subject is within the effective flash range (page 9). I To automatically set exposure and focus, press the Shutter button halfway. When the Ready light glows green, press the Shutter button completely down to take the picture. I Use Auto, Landscape, or Close-up to adjust the exposure compensation. Picture is not clear I To automatically set exposure and focus, press the Shutter button halfway. When the Ready light glows green, press the Shutter button completely down to take the picture. I Clean the lens (page 59). I Make sure camera is not in Close-up mode if you are more than 27.6 in. (70 cm) from your subject. I Place the camera on a flat, steady surface or use a tripod, especially in high-zoom settings or in low light. Camera ready light status If... Try one or more of the following Ready light does I Turn on the camera (page 2). not turn on and the I Recharge the battery or install a new one (page 1). camera does not work I Mode dial was on when battery was reloaded. Turn Mode dial off, then back on. Ready light blinks I Picture is being processed and saved to the camera. Camera is green operating normally. I Camera is connected. Camera is operating normally. Ready light blinks I Recharge the battery or install a new one (page 1). red and camera turns off www.kodak.com/go/support 45

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74

Troubleshooting
www.kodak.com/go/support
45
Camera ready light status
Picture is too light
Reposition camera to reduce the amount of available light.
Turn flash off (
page 26
).
Move so that the distance between you and the subject is within the
effective flash range (
page 9
).
To automatically set exposure and focus, press the Shutter button
halfway
. When the Ready light glows green, press the Shutter
button
completely down
to take the picture.
Use Auto, Landscape, or Close-up to adjust the exposure
compensation.
Picture is not clear
To automatically set exposure and focus, press the Shutter button
halfway
. When the Ready light glows green, press the Shutter
button
completely down
to take the picture.
Clean the lens (
page 59
).
Make sure camera is not in Close-up mode if you are more than
27.6 in. (70 cm) from your subject.
Place the camera on a flat, steady surface or use a tripod, especially
in high-zoom settings or in low light.
If...
Try one or more of the following
Ready light does
not turn on and the
camera does not
work
Turn on the camera (
page 2
).
Recharge the battery or install a new one (
page 1
).
Mode dial was on when battery was reloaded. Turn Mode dial off, then
back on.
Ready light blinks
green
Picture is being processed and saved to the camera. Camera is
operating normally.
Camera is connected. Camera is operating normally.
Ready light blinks
red and camera
turns off
Recharge the battery or install a new one (
page 1
).
If...
Try one or more of the following