Kyocera ECOSYS FS-1320D FS-1120D/1320D Operation Guide Rev-1 - Page 64
General Information, Toner Container Replacement, Frequency of toner container replacement
View all Kyocera ECOSYS FS-1320D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
General Information This chapter describes basic maintenance tasks you can perform for the printer. You can replace the toner container according to the printer's status: Also, the internal parts need periodic cleaning. Note Information Collection on Memory Chips - The memory chip attached to the toner container is designed to improve convenience for the end user; to support the recycling operation of empty toner containers; and to gather information to support new product planning and development. The information gathered is anonymous - it cannot be associated to any specific individual and the data is intended to be used anonymously. Toner Container Replacement The Toner indicator identifies the toner status at two stages of toner usage. • When the printer becomes low on toner, the Toner indicator flashes. Note the replacement is not always necessary at this stage. • If you ignore the above status and continue printing, the Toner indicator lights up just before the toner is used up. The toner container must then be replaced immediately. In either case, replace the toner container. Frequency of toner container replacement Assuming an average toner coverage of 5% and EcoPrint mode turned off, the toner container will need replacing approximately once every 7,200 pages (FS-1320D) or 2,500 pages (FS-1120D). Starter Toner Container The toner container packed with the new printer is a starter toner container. The starter toner container lasts an average of 2,300 pages (FS-1320D) or 1,000 pages (FS-1120D). Toner Kits For best results, we recommend that you only use genuine Kyocera Parts and Supplies. A new toner kit contains the following items: • Toner Container • Plastic waste bag for old toner container • Installation Guide Note Do not remove the toner container from the carton until you are ready to install it in the printer. 4-2 Maintenance