Kyocera FS-C8500DN FS-C8500DN Installation Instructions - Page 2

4 Loading Paper 1 Pull the paper cassette out toward you until it stops. 2 Adjust the paper length guide to the 3 Grasp the paper width adjustment length of the paper. knob and adjust the paper width guides When loading A4/Letter or smaller paper to the width of the paper. into paper cassette 1, raise the paper length guide. For B4/Legal or larger paper, lower the paper length guide. 4 Fan the paper, then tap it on a level surface to avoid media jams or skewed printing. Paper Length Guide Paper Width Adjustment Knob 5 Align the paper against the left side of the paper cassette. Important: Ensure that the loaded paper is not higher than the level indicator (see illustration below). 6 Insert the appropriate paper size card in the slot to indicate the size of the paper. 7 Gently push the paper cassette back in. Level Indicator 5 Connecting Cables 1 Turn the power switch off (O). 2 Connect the printer to the PC or your network device. Use shielded interface cables. These cables are sold separately. 3 Connect the power cord to the printer and the other end into a power outlet. 4 Turn the power switch on (|). Important: When the printer is first switched on after installation, the printer will begin cleaning the LSU; this will take approximately 70 seconds. Network Interface USB Interface Refer to the Operation Guide to install the printer driver and to set network parameters. © 2009 by KYOCERA MITA Corporation All rights reserved. 2-28, 1-Chome, Tamatsukuri, Chuo-ku, Osaka 540-8585, Japan Printed in China 302KA56030 First edition 2009.10