Kyocera TASKalfa 3051ci Printing System (11),(12),(13),(14) Release Notes (Fie - Page 1
Kyocera TASKalfa 3051ci Manual
View all Kyocera TASKalfa 3051ci manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Customer Release Notes Fiery E100 Color Server, version 1.0 Setup Printing This document contains important information about this release. Be sure to provide this information to all users before proceeding with the installation. NOTE: This document uses the term "E100" to refer to the Fiery E100 Color Server. Name appears more than once during printer driver installation from AppleTalk If there are multiple E100 servers in the same network, the printer names appear similar, and it may be difficult to identify the specific printer to which you want to connect. Because the first 11 characters of the server name are displayed, keep the first 11 characters of the server name different for each E100. To change the server name, go to Configure > Server > General. Bonjour printers When you add a Bonjour printer on a Mac OS X computer, select the Bonjour printer that starts with "Kyocera Fiery E100." The Bonjour printer that is listed simply as the server name is for Direct Mobile Printing (if you select this, the Add button is disabled). AutoSelect output tray in printer driver When the output tray is set as AutoSelect in the printer driver, and if a job does not have finishing options (staple, punch, fold) nor size constraints for trays, the job is output to one of the following trays, depending on the configuration: • Tray B (4000 sheet finisher) • Top Tray (1000 sheet finisher) • Inner Tray (if no finisher is connected to a TASKalfa 3550ci-5550ci) • Lower-left Tray (if no finisher is connected to a TASKalfa 6550ci-7550ci) This output handling occurs regardless of the default tray set on the copier. For example, a job with paper size Letter and no finishing options goes to Tray B (when the 4000 sheet finisher is connected), even though Tray A is set as the default at the copier. If you use Mixed Media settings in the printer driver, the output is handled as follows: • If the mixed media job contains a custom page size, you cannot choose Auto Select as the output tray. Instead, you are prompted to change the output tray to Tray C. Therefore, all output goes to Tray C if the 4000 sheet finisher is installed, and to Top Tray if the 1000 sheet finisher is installed. • If the mixed media job does not contain a custom page size, the output goes to the next available and supported output tray in the order listed in the printer driver. Copyright 2011 © Electronics For Imaging, Inc. 45098278 23 June 2011 *45098278*