Kyocera TASKalfa 4551ci PRESCRIBE Commands Technical Reference Manual - Rev. 4 - Page 105
Interface-independent Parameters, Table 6.2. - fuser
View all Kyocera TASKalfa 4551ci manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
e V0-V3 - Default (power-up) font These parameters define the default font at power up. The V3 parameter accepts a scalable font name of up to 32 characters and defines it to be the power-up font. The factory-set default font is Courier. The V0, V1, and V2 parameters specify the height of the font. The default size is 012.00 points (00, 12, 00, respectively). The V0-V3 parameters are ignored if the specified font is not present at power-up, and the printing system selects Courier as the default font for V3. The example below gives the PRESCRIBE sequence which changes the default font to TimesNewRoman, 14.25 points: !R! FRPO V3, 'TimesNewRoman'; FRPO V0, 0; FRPO V1, 14; FRPO V2, 25; EXIT; The power-up font can be a simulated bitmap font by giving a font number to the C5, C2 and C3 parameters in the same manner as for V0, 1 and 2. This will set the V3 value to null. Interface-independent Parameters Table 6.2. Interface-independent Parameters (Sheet 1 of 8) Environment Parameter Value Factory setting Downloadable PCL font B0 compression 0: Off 1: On 0 (countries excluding Asia) or 1 (Asia) Message language B7 selection at power-on 0: Automatically enters message language 1 selection menu at the initial power-on. After a language is selected, B7=1 is set automatically. 1: Does not automatically enter message language selection menu at power-on. Default pattern B8 0: 300 dpi 0 resolution (PAT, FPAT, GPAT) 1: 600 dpi 3: 1200 dpi Minimum memory B9 allocation for resource protection/(in duplex mode) 0: 12 MB or more (16 MB or more) 1: 10 MB (14 MB) 2: 8 MB (12 MB) 3: 6 MB (10 MB) 0 or 1 4: 4 MB (8 MB) 5: 2 MB (6 MB) Copy count C0 Number of copies to print:1-999 1 KPDL font range C9 0: KPDL fonts only 0 1: KPDL and PCL fonts Serial line control D0 0: XON is sent every 5 seconds during the 0 printing system is ready or waiting. Error is ignored. 1: XON is sent every 5 seconds during the printing system is ready or waiting. Error is valid. 10: XON is not sent. Error is ignored. 11: XON is not sent. Error is valid. A4 full page bleeda D1 0: Off 0 1: On Audio alarm D2 0: Off 1 1: On Paper size error D3 0: Not notified 0 1: Notified 2: Complies with MS certification Print density D4 Number from 1 (Light) to 5 (Dark) 3 Service status page D5 0: Not printed 1 1: Printed Paper jam retry timing D6 0: End of page 0 1: Fuser sensor activated 2: Fuser sensor deactivated 3: Page ejection 4: Same as 0; non-engine-dependent Host buffer size H0 0 to 99 in units of 10MB (0 to 990MB) 0 6-5