Kyocera TASKalfa 6500i 6500i/8000i Operation Guide Rev-1 2011.4 - Page 363

Default Setting (System Menu) Correcting Black Lines Correct fine lines (streaks caused by contamination), which may appear on the image, when the document processor is used. Paper feed direction (streaks caused by contamination) The table below shows the available settings. Item Off On(Low) On(High) Description No correction performed. Correction performed. Select this item if a streak remains after using [On (Low)]. The reproduction of fine lines on the original may becomes lighter than when using [On (Low)]. Use the procedure below to specify the setting for correcting fine black lines. 9 1 Press the System Menu key. 2 Press [ ], [Adjustment/Maintenance] and then [Change] of Correcting Black Line. 3 Press [Off], [On(Low)] or [On(High)]. 4 Press [OK]. System Initialization Initialize the hard disk installed on the machine to return it to the factory defaults.. Refer to System Initialization on page 9-89 about the initialization procedures. 9-67