LG 42LT560E Quick Reference Guide - Page 7

TABLE OF CONTENTS 7 TABLE OF CONTENTS 2 LICENSES 2 OPEN SOURCE SOFTWARE NOTICE 3 IMPORTANT SAFETY INSTRUCTIONS 7 TABLE OF CONTENTS 8 INSTALLATION PROCEDURE 8 ASSEMBLING AND PREPARING 8 Unpacking 10 Optional Extras (For LT560E series) 11 Parts and buttons 12 Setting up the TV 12 - Attaching the stand 14 - Mounting on a table 15 - Mounting on a wall 17 - Tidying cables 17 - External speaker out 18 REMOTE CONTROL 20 GENERAL TROUBLESHOOTING 20 CAUTION for using ezsign 2.0 21 SPECIFICATIONS 23 IR CODES 24 EXTERNAL CONTROL DEVICE SETUP 24 RS-232C Setup 24 Type of connector; D-Sub 9-Pin Male 25 RS-232C configurations 26 Communication Parameters 26 Command reference list 27 Transmission / Receiving protocol ENEGNLGISH FCC NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and the receiver. - Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation of the device. Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.