LG 42SH7DB User Guide - Page 34
PICTURE ID Settings
View all LG 42SH7DB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
ENGLISH 34 PICTURE ID Settings AUDIO •• Only applies to certain models. (RGB/DVI) RS-232C OUT RS-232C OUT RS-232C OUT is used to change the settings of a specific set (display) using a single IR receiver for multi-vision. RS-232C IN RS-232C IN RS-232C IN Communication is REMOTE CONTROL IN possible between a monitor with an IR receiver and other monitors using RS-232C cables. Each monitor is identified by a Set ID. If you assign the using the remote control, only displays with matching and Set ID can be controlled remotely. 1 Assign the Set ID to the installed monitors as shown below. IR & Light Sensor RS-232C cables PICTURE ID ON [2] 2 Press the red ON button on the remote control to assign the PICTURE ID. 3 Assign the Set ID to the selection of your choice. •• A set with a different Set ID from the PICTURE ID cannot be controlled by IR signals. NOTE •• If PICTURE ID is set to 2, only the upper right monitor, which has a Set ID of 2, can be controlled by IR signals. •• If you press the green OFF button for PICTURE ID, the PICTURE IDs for all monitors are turned off. If you then press any button on the remote control, all monitors can be controlled by IR signals regardless of Set ID.