LG DLE1310W Owner's Manual - Page 12
Changing The Dryer Vent Location - side vent kit
View all LG DLE1310W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
CHANGING THE DRYER VENT LOCATION wWARNING • Use a heavy metal vent. • Do not use plastic or thin foil duct. • Clean old ducts before installing this dryer. • Wear gloves during installation. • Failure to follow these instructions can result in death or fire. Your new dryer is shipped to vent to the rear. It can also be configured to vent to the bottom or side (right-side venting is not available on gas models). An adapter kit, part number 383EEL9001B, may be purchased from your LG retailer. This kit contains the necessary duct components to change the dryer vent location. OPTION 1: Side Venting Adapter duct Retaining Screw Rear Exhaust Duct 1 Remove the rear exhaust duct retaining screw. Pull out the exhaust duct. OPTION 2: Bottom Venting Adapter Duct Bracket Knockout 2 Press the tabs on the knockout and carefully remove the knockout for the desired vent opening (right-side venting is not available on gas models). Press the adapter duct onto the blower housing and secure to the base of the dryer as shown. Bracket 2 Press the adapter duct onto the blower housing and secure to the base of the dryer as shown. Cover Plate Elbow 11/2" (3.8 cm) 3 Preassemble a 4-in. (10 cm) elbow to the next 4-in. (10 cm) duct section, and secure all joints with duct tape. Be sure that the male end of the elbow faces AWAY from the dryer. Insert the elbow/duct assembly through the side opening and press it onto the adapter duct. Secure in place with duct tape. Be sure that the male end of the duct protrudes 1½ in. (3.8 cm) to connect the remaining ductwork. Attach cover plate to the back of the dryer with included screw. 12 Cover Plate Elbow 3 Insert the 4-in. (10 cm) elbow through the rear opening and press it onto the adapter duct. Be sure that the male end of the elbow faces down through hole in the bottom of the dryer. Secure in place with duct tape. Attach the cover plate to the back of the dryer with included screw.