LG DLE7060WE Owners Manual - Page 50
Error Codes
View all LG DLE7060WE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Troubleshooting 49 ENGLISH Error Codes Problem Error code: tE1 through tE7 Display shows error code: PS (electric dryers only) *Flow SenseTM indicator shows four bars during the drying cycle or the display shows "d80" after drying Possible Cause Temperature sensor failure. Power cord is connected incorrectly. Exhaust system is too long or has too many turns/restrictions. Partial blockage of the ductwork due to lint buildup or other foreign object. * This warning light is not a dryer failure and is not covered by the dryer warranty. Contact a duct cleaning service to set up an appointment to have your exhaust system cleaned and inspected. The Flow SenseTM indicator remains active after clearing the restriction in the venting. The appliance has detected a restriction in the external dryer venting. After clearing the restriction, the Flow SenseTM system requires multiple, consecutive cycles to determine that the performance value has improved before the Flow SenseTM indicator is reset. Lint filter not cleaned properly. indicator light is on during the drying cycle Solutions Turn off the dryer and call for service. Check the connection of the power cord to the terminal block. Install a shorter or straighter duct run. See the Installation Instructions for details. Ductwork should be checked/cleaned immediately. Dryer can be used in this condition, but drying times will be longer and energy consumption will increase. If exhaust restrictions are sensed by the Flow SenseTM system, the indicator will remain on for 2 hours after the end of the cycle. Opening the door or pressing the POWER button will turn off the display. If the Flow SenseTM indicator remains active for more than five cycles after the restriction has been cleared, call for service. Remove the lint from the filter before every load. With the lint removed, hold the filter up to a light to see if it is dirty or clogged. If it looks dirty, follow the cleaning instructions. With some loads that produce high amounts of lint, it may be necessary to clean the filter during the cycle.