LG DLG3601V Owners Manual - Page 27
Four-Wire Direct Wire, ENGLISH
View all LG DLG3601V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
ENGLISH Four-Wire Direct Wire ••A UL-listed strain relief is required. ••Use UL-listed 4-wire #10 AWGminimum copper conductor cable. Allow at least 5 ft. (1.5 m) of wire to allow for removal and reinstallation of the dryer. INSTALLATION 27 6 Attach the two hot leads of the power cord to the outer terminal block screws. 7 Attach the white neutral wire to the center screw of the terminal block. 8 Attach the power cord ground wire to the green ground screw. 9 Tighten all screws securely. 1 Remove 5-inch (12.7 cm) of the outer covering from the wire. Remove 5-inch of insulation from the ground wire. Cut off approximately 1.5-inch (3.8 cm) from the other three wires and strip 1 inch (2.5 cm) insulation from each wire. Bend the ends of the three shorter wires into a hook shape. 1" (2.5 cm) Ground Wire 5" (12.7 cm) 10 Reinstall the terminal block access cover. Hot (Black) Neutral (White) Ground Screw Hot (Red) White Wire moved from Ground Screw Power Cord Ground Wire 2 Remove the terminal block access cover on the upper back of the dryer. 3 Install a UL-listed strain relief into the power cord through-hole. 4 Thread the 4-wire #10 AWG-minimum copper power cable prepared in step 1 through the strain relief. Terminal Block UL-Listed Strain Relief UL-Listed 4-Wire Power Cord 5 Transfer the dryer's ground wire from behind the green ground screw to the center screw of the terminal block.