LG DVT654 Operation Guide - Page 37

Presetting the Radio Stations Listening to the Radio You can preset 50 stations for FM and AM (MW). Before tuning, make sure that you have turned down the volume. 1. Press FM/AM on the remote control until FM or AM (MW) appears in the display window. 2. And then every time you press FM/AM, FM and AM (MW) changes alternately. 3. Press and hold TUN + or the Remote Control for about two seconds until the frequency indication starts to change, then release. Scanning stops when the DVD/CD Receiver tunes in a station. "TUNED" and "ST." (for stereo program) appear in the display window. 4. Press PROG/MEMO. on the Remote Control. A preset number will flash in the display window. Preset radio stations in the DVD/CD Receiver's memory first (see "Presetting radio stations" on the left). 1. Press FM/AM until AM (MW) or FM appears in the display window. The last received station is tuned in. 2. Press PRESET +/- repeatedly on the remote control to select the preset station you want. Each time you press the button, the DVD/CD Receiver tunes in one preset station at a time. 3. Adjust the volume by rotating VOLUME on the front panel or by pressing VOLUME + or - on the remote control repeatedly. To turn off the radio Press POWER to turn the DVD/CD receiver off or select another function mode (DVD/CD, AV 1, etc.,). 5. Press PRESET + or - on the To listen to non-preset radio stations Remote Control to select the preset number you want. Use manual or automatic tuning in step 2. 6. Press PROG/MEMO. on the Remote Control again. The station is stored. 7. Repeat steps 3 to 6 to store other stations. For manual tuning, press TUNING or on the front panel repeatedly. For automatic tuning, press and hold TUNING To tune in a station with a weak signal or front panel. for about two seconds on the Press TUNING or repeatedly in step 3 to tune in the station manually. To clear all the stored stations Press and hold PROG/MEMO for about two seconds and "CLEAR ALL" is appeared in the display window and then press PROG/MEMO again, the stations are cleared. If you have accidentally entered into the "CLEAR ALL" mode and you do not wish to clear the memory, do not press any key. After a few seconds, the "CLEAR ALL" display will go off by itself and change to normal mode. To select a preset radio station directly You can use the number buttons on the remote control to select a preset radio station directly. For example, to listen to preset station 4, press 4 on the remote control. To listen to preset station 19, press 1 then 9 (within 3 seconds). For your reference If an FM program is noisy Press MONO/ST. on the front panel so that "ST." disappears in the display window. There will be no stereo effect, but the reception will improve. Press the button again to restore the stereo effect. Note: If all stations have already been entered, the FULL message will appear in the display window for a moment and then a preset number will flash. To change the preset number, follow the steps 5-6 as above. To improve reception Reorient the supplied antennas. Operation 37