LG LMV1314W Owner's Manual (English) - Page 23

MAINTENANCE WARNING - Disconnect power supply before replacing parts or cleaning. Do not let water or detergent in unit, they may result in electrical shock hazard or electrical trouble on unit. CARE AND CLEANING For best performance and safety, keep the oven clean inside and outside. Take special care to keep the inner door panel and the oven front frame free of food or grease build-up. Never use rough powder or pads. Wipe the microwave oven inside and out, including the hood bottom cover, with a soft cloth and a warm (not hot) mild detergent solution. Then rinse and wipe dry. Use a chrome cleaner and polish on chrome, metal, and aluminum surfaces. Wipe spatters immediately with a wet paper towel, especially after cooking chicken or bacon. Clean your oven weekly or more often, if needed. CHARCOAL FILTER REPLACEMENT NOTE: The charcoal filter is only for some ovens which are vented inside initially or changed to be vented inside. If your oven is vented outside, see the next instructions. The charcoal filter should be replaced every 6 to 12 months, and more often if necessary. The charcoal filter cannot be cleaned. To order a new charcoal filter, contact your dealers parts department. 1. Remove the two vent grille mounting screws. (2 middle screws) CLEANING THE GREASE FILTERS The grease filters should be removed and cleaned often, at least once a month. 1. To remove grease filters, slide each filter to the side. Pull filters downward and push to the other side. The filter will drop out. 2. Tip the grille forward, then lift it out 3. Remove old filter. 4. Slide a new charcoal filter into place. The filter should rest at the angle shown. 2. Soak grease filters in hot water and a mild detergent. Rinse well and shake to dry. Do not use ammonia or place in a dishwasher. The aluminum will darken. 3. To reinstall the filters, slide it into the side slot, then push up and toward oven center to lock. 5. Slide the top of the vent cover into place. Push the bottom until it snaps into place. Replace the mounting screws. Turn the power back on at the main power supply and set the clock. COOKTOP LIGHT REPLACEMENT 1. Unplug the oven or turn off power at the main power supply. 2. Remove the bulb cover mounting screws. NOTE: Do not operate the hood without the filters in place. 3. Replace bulb(s) with 30 watt appliance bulb(s). 4. Replace bulb cover. 5. Turn the power back on at the main power supply. - 23 -