LG LMV1762ST INSTALLATION - Page 9
Prepare The Venting Blower
View all LG LMV1762ST manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
STEP 3: Prepare The Venting Blower Your microwave oven is shipped with the blower assembled for roof-venting. You need to adjust the blower if you want wall-venting or room-venting installation. wW A R N I N G ELECTRIC SHOCK HAZARD! UNPLUG UNIT BEFORE WORKING ON IT. • DO NOT PULL OR STRETCH THE BLOWER WIRING! Pulling and stretching the blower wiring could result in electric shock. 1. Remove any shipping materials and parts from inside the microwave oven. Set them aside for later use. 2. Cover the counter top or cooktop with a thick, protective covering to protect it from damage and dirt. See Figure 11. NOTE: If you have a free-standing range, disconnect it, move it onto a piece of cardboard or hardboard and pull it away from the wall, so that you can get closer to the upper cabinet and back wall for easier measuring and drilling. NOTE: Set the product down on a flat surface only. A thick, protective covering 3. Locate the exhaust adaptor, grease filters and hardware packet. 4. At this point, remove any adhesive tape (if there is any), on the exhaust adaptor, the grease filters and the power supply cord. Figure 11 Damper • Do not remove the packing tape on the slide-out vent. ROOF-VENTING INSTALLATION: This oven is shipped assembled for roof-venting. 1. Insert the tabs on each side of the damper into the holes at the inside rear of the adaptor. Attach the exhaust adaptor to the blower plate with the two tapping screws provided. See Figure 12. Make sure that the damper swings freely. EAEAxdhxdahaapauptusottsor tr Blower Plate Back of Oven Figure 12 wW A R N I N G FIRE HAZARD! CORRECTLY INSTALL THE VENT FAN BEFORE USE . • When changing the vent fan position for a rear wall vent or room vent: 1. Properly align the ventilation fan openings and blower plate knockouts. 2. Ventilation fan openings should be completely exposed to the outside. 3. After installation, check the air ventilation path. Refer to page 7 Figures 6-8 for proper vent selection. •Improper installation can cause problems such as: 1. Inability to assemble blower plate or ventilation motor correctly. 2. Abnormal noise during product operation. 3. Weak ventilation. 4. Product overheating - possibility of product breakdown or fire. - 9 -