LG LRFXS2503D Owners Manual - Page 20

Assembling the Left Refrigerator

Get LG LRFXS2503D PDF manuals and user guides View all LG LRFXS2503D manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

20 INSTALLATION 4 Place the cover e in its place. Insert and tighten the cover screw f . 3 Connect all the wire harnesses and the ground screw. Assembling the Left Refrigerator Door CAUTION • Install the left refrigerator door after the right door is installed. 1 Make sure that the plastic sleeve is inserted in the bottom of the door. Install the refrigerator door onto the middle hinge. 4 Push the water supply tube into the hole on the top case and pull it through the backplate. 5 Hold the water supply connection and gently push in the collet d to connect the water supply line as shown. Insert the tube at least 5/8 inch (15 mm) into the connector. Insert the clip on the joint to fasten the tube in place. 2 Fit the hinge a over the hinge lever latch b and slot it into place. Rotate the lever c clockwise and fasten the hinge. NOTE • Disassembling/Assembling the Water Lines e Collet f Tube g Insert line h Clip

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
20
INSTALLATION
4
Place the cover
e
in its place. Insert and
tighten the cover screw
f
.
Assembling the Left Refrigerator
Door
CAUTION
•
Install the left refrigerator door after the right
door is installed.
1
Make sure that the plastic sleeve is inserted in
the bottom of the door. Install the refrigerator
door onto the middle hinge.
2
Fit the hinge
a
over the hinge lever latch
b
and slot it into place. Rotate the lever
c
clockwise and fasten the hinge.
3
Connect all the wire harnesses and the
ground screw.
4
Push the water supply tube into the hole on
the top case and pull it through the backplate.
5
Hold the water supply connection and gently
push in the collet
d
to connect the water
supply line as shown. Insert the tube at least
5/8 inch (15 mm) into the connector. Insert
the clip on the joint to fasten the tube in place.
NOTE
•
Disassembling/Assembling the Water Lines
e
Collet
f
Tube
g
Insert line
h
Clip